What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
11.06.2025 14:59

What does a fuse do?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The S&P 500 closes at 6,000 as bulls aim for return to record territory - MarketWatch
[image of Common-mode choke]
The MOV will conduct when the voltage exceeds 50% of line voltage.
(Dc diagram shown, AC is similar).
What life lesson did you learn the hard way?
He then asserts :
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is 'the assistant's answer'
Why do some people have sex with dogs?
There are three different concepts here that are getting confused.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Here is a simplified AC power diagram.
These devices are installed between the “hot” and “neutral” and protective ground.
One
The other is “what does a “fuse” do?”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Barnstars:
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It also is a device that limits the change in current flow.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
'Club World Ca$h Grab': Players don protest shirts at pregame - Sounder at Heart
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is where this question deviates from being a 'generic' question, and becomes more specific.
[old diagram got deleted by accident]
Man charged in shooting outside Wayzata High School graduation - kare11.com
but this device (an Inductor) … impedes the rapid changes in the current.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Forget drones, Amazon has new robots that could replace humans - TheStreet
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Because the load is inductive, the current lags the voltage.(by a bit).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Appendix cancers on the rise in younger generations, study finds - NBC News
Upvotes:
These are simplified answers to the original question, and does not change anything I wrote above.
This device then solves the entire problem.
Campbell’s Snack Business Struggles as Consumers Get Pickier About Food Spending - WSJ
In schematic diagrams this is the symbol for a fuse:
what exactly is a ‘surge’ protector?
The third is lightning and “how it gets conducted into a home.”
Why does my vagina and around my butthole itch? I don't have weird discharge and I'm still a virgin.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–10[John johnson John Johnson ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
eight
He then describes the function of a fuse.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
a photo is worth a thousand words.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But it can get overloaded, and no longer works.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
It seems Mohan does not understand the difference between a comment and an Answer.
He then describes Rainy Season and Lightning.
The bolt then partially travels down the line to your home.
An AC voltage/ current source, and an ac inductive load.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This one hit behind the barn.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Edit 2024–10.
A fuse is a non-resetable over current circuit protector.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
nine
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
I post the exact comment here.
For this case there are devices called Metal oxide varistors (MOV).
So, the voltage could go up to 500 volts, and the fuse will not open up.
First Sentence:
There are two important concepts here.
What is lightning?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
A circuit breaker is similar, but is resettable.
but I think this circuit , shows a few more pieces.
the problem then depends on "how fast does the fuse operate?".
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is where the MOV conducts again, and dissipated the energy.
so, what happens?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Now when you have a certain ac resistance, then a current flows in a loop.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At least they know the answer if they wanted it.